Preparing The Mower; Installing The Bagger Mounting Bracket; Step; No Parts Required - Toro 78534 Operator's Manual

Note: Determine the left and right sides of the machine from the normal operating position.

Step

1

Preparing the Mower

No Parts Required

Procedure
Perform the following procedure to prepare the
mower for attaching the blower and finishing kit.
1. Disengage the PTO, move the motion control
levers to the neutral locked position and set
the parking brake.
2. Stop the engine, remove the key, and wait for
all moving parts to stop before leaving the
operating position.
3. Repair all bent or damaged areas of mower
deck and replace any missing parts.
4. Clean the mower of any debris on the deck or
rear part of the mower to ease installation.
Step
2
Installing the Bagger
Mounting Bracket
Parts needed for this step:
1

Bagger mounting bracket

2

Bagger side plate

2 Spacer
14 Bolt, (3/8 x 1-1/2 inches)
2 Bolt, (3/8 x 1 inch) (for Z593 mowers only)
14 Flange Nut, (3/8 inch)
14
Curved washer
Procedure
Important: Do not tighten any bolts until
both side brackets and bagger mounting
bracket are fit loose on the machine.
Refer to Tightening the Mounting Bolts for
the correct procedure to tighten the bolts.
1. Remove the bolts, nuts, and washers holding
the roll bar to one side of the machine. Discard
the nuts, bolts, and washers (Figure 4, Figure 5,
and Figure 6).
2. Install the bagger side plate and the roll bar
section to the side of the machine using 4 bolts
(3/8 x 1-1/2 inches), 4 curved washers (3/8
inch), and 4 flange nuts (3/8 inch) (Figure 4,
Figure 5, and Figure 6).
3. Repeat the steps above for the opposite side
(Figure 4, Figure 5, and Figure 6).
Note: Make sure the curved washers are
installed as shown in Figure 4, Figure 5, and
Figure 6.
4. Install the bagger mounting bracket to the left
and right side bagger brackets with 4 bolts
(3/8 x 1-1/2 inches), 4 curved washers (3/8
inch), and 4 flange nuts (3/8 inch) (Figure 4,
Figure 5, and Figure 6).
5. Install the bagger mounting bracket to the
rear frame of the machine with 2 bolts (3/8 x
1-1/2 inches) (use 2 bolts (3/8 x 1 inch) for
Z593 mowers as shown in Figure 5), 2 curved
7