Table of Contents
Advertisement
Figure 49
1. Spring-loaded idler pulley
9.
Install the belt onto the spring-loaded idler pulley
(Figure
49).
Greasing the Idler Arm
Service Interval: Every 50 hours
Grease the bagger belt idler arm
50 hours.
Figure 50
g038292
2. Spring
(Figure
50) every
g375864
Inspecting the Bagger
Service Interval: Every 100 hours
After the first 8 hours
1.
Disengage the PTO, move the motion-control
levers to the N
engeage the parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Check the upper tube, lower tube, bagger hood,
and the blower assembly. Replace these parts if
they are cracked or broken.
4.
Check the bags, bagger frame, and screen.
Replace any parts that are cracked or broken.
5.
Tighten all nuts, bolts, and screws.
Inspecting the Mower
Blades
1.
Inspect the mower blades regularly and
whenever a blade strikes a foreign object.
2.
If blades are badly worn or damaged, install
new blades. Refer to your machine Operator's
Manual for complete blade maintenance.
Selecting the Mower Blades
In most mowing conditions, the standard high lift
blades provide the best bagging performance.
The Toro Atomic blade is recommended for bagging
leaves in dry conditions. In dry dusty conditions, the
medium lift or low lift blades reduce dust and dirt
blowout while providing effective bagging air flow.
Contact an Authorized Service Dealer for the proper
blades for different mowing conditions.
Refer to the machines Operator's Manual for more
information on installing blades.
37
-
position, and
EUTRAL
LOCK
Advertisement
Table of Contents
