Table of Contents
Advertisement
NOTE:
NVDIMM-N memory slots are not hot-pluggable.
Next steps
1.
Install the air shroud.
2. Follow the procedure listed in
3. To verify if the memory module has been installed properly, press F2 and go to System Setup Main Menu > System BIOS
> Memory Settings. In the Memory Settings screen, the System Memory Size must reflect the updated capacity of the
installed memory.
4. If the value is incorrect, one or more of the memory modules may not be installed properly. Ensure that the memory module
is firmly seated in the memory module socket.
5. Run the system memory test in system diagnostics.
NVDIMM-N battery
Removing the NVDIMM-N battery
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
CAUTION:
To prevent data loss, ensure that your system and LEDs on NVDIMM-N and NVDIMM-N battery are
turned off before removing the NVDIMM-N battery.
CAUTION:
To avoid damage to the battery connector, you must firmly support the connector while installing
or removing a battery.
3. Disconnect the cables from the NVDIMM-N battery.
Steps
1. Using the Phillips #2 screwdriver, loosen the screw securing the NVDIMM-N battery.
2. Holding the edges, lift the NVDIMM-N battery away from the system.
Figure 41. Removing the NVDIMM-N battery
Next steps
1.
Install the NVDIMM-N
64
Installing and removing system components
After working inside your system
Safety instructions
Before working inside your system
battery.
on page 35.
on page 34.
on page 35.
Advertisement
Table of Contents
