2
Follow the procedure listed in
3
To verify if the memory module has been installed properly, press F2 and navigate to System Setup Main Menu > System BIOS >
Memory Settings. In the Memory Settings screen, the System Memory Size must reflect the updated capacity of the installed
memory.
4
If the value is incorrect, one or more of the memory modules may not be installed properly. Ensure that the memory module is firmly
seated in the memory module socket.
5
Run the system memory test in system diagnostics.
NVDIMM-N battery
Removing the NVDIMM-N battery
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
CAUTION:
off before removing the NVDIMM-N battery.
CAUTION:
removing a battery.
3
Disconnect the cables from the NVDIMM-N battery.
Steps
1
Using the Phillips #2 screwdriver, loosen the screw securing the NVDIMM-N battery.
2
Holding the edges, lift the NVDIMM-N battery away from the system.
Figure 36. Removing the NVDIMM-N battery
Next step
1
Install the NVDIMM-N
92
Installing and removing system components
After working inside your
Safety
instructions.
Before working inside your
To prevent data loss, ensure that your system and LEDs on NVDIMM-N and NVDIMM-N battery are turned
To avoid damage to the battery connector, you must firmly support the connector while installing or
battery.
system.
system.