Nvdimm-N Battery; Removing The Nvdimm-N Battery - Dell 5WC10 Installation And Service Manual

Figure 64. Installing the slim optical drive blank
Next steps
1. Install the optical drive
2. Follow the procedure listed in

NVDIMM-N battery

Removing the NVDIMM-N battery

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
CAUTION: To prevent data loss, ensure that your system is turned off and that the indicator LEDs on the
battery are Off before removing the NVDIMM-N battery.
CAUTION: To avoid damage to the battery connector, you must firmly support the connector while installing
or removing a battery.
3. Remove the NVDIMM-N battery cage.
Steps
1. Disconnect the cables from the NVDIMM-N battery.
2. Using the Phillips #2 screwdriver, loosen the screw securing the NVDIMM-N battery.
3. Holding the edges, lift the battery from the NVDIMM-N battery cage.
cage.
After working inside your system
Safety instructions
Before working inside your system
on page 67.
on page 66.
on page 67.
Installing and removing system components 107