Table of Contents
Advertisement
CAUTION:
Do not lift the system board by holding a memory module, processor, or other components.
CAUTION:
Take care not to damage the system identification button while placing the system board into the
chassis.
2. Holding the post and release pin, incline the system board, and lower the system board into the chassis.
3. Slide the system board toward the back of the system until the release pin clicks into place.
Figure 117. Installing the system board
Next steps
1. Replace the following:
a.
Trusted Platform Module (TPM)
b.
Integrated storage controller card
c.
Internal USB key (if applicable)
d.
USB 3.0 module (if applicable)
e.
All expansion cards and risers
f.
Processors and heat sink modules
g. Processors blanks (if applicable)
h.
Memory modules
and memory module blanks
i.
Network daughter card
j.
Air shroud
2. Reconnect all cables to the system board.
NOTE:
Ensure that the cables inside the system are routed along the chassis wall and secured using the cable securing
bracket.
3. Follow the procedure listed in
4. Ensure that you:
a. Use the Easy Restore feature to restore the Service Tag For more information, see the
using the Easy Restore
b. If the Service Tag is not backed up in the backup flash device,
c. Update the BIOS and iDRAC versions.
d. Re-enable the Trusted Platform Module (TPM). For more information, see the
section.
5. Import your new or existing iDRAC Enterprise license.
After working inside your system
feature section.
on page 35.
enter the Service Tag
Upgrading the Trusted Platform Module
Installing and removing system components
Restoring the Service Tag by
manually.
127
Advertisement
Table of Contents
