Table of Contents
Advertisement
ASSEMBLY
The handle assembly must be mounted to the machine.
If left hand operation is required, repeat the steps below on
the opposite side of the machine.
1. Install the cover over the handle using two M6-1 x 16
capscrews (#66).
2. Tighten the handle assembly adjustment knob (#12) to fix
the handle in position.
3. If needed, extend the handle further from the adjustment
knob to obtain greater torque.
4. Thread both rods (#50) into the lower set of holes as shown in (fig.3).
These holes are located on the out feed side of the casting. With the
flange pointing up, the stop assembly is used for the brake. If the
flange points down, the stop assembly is used for the shear.
5. Fasten both stand dies (#49) to the back gauge (#48). The stand dies
can now be positioned where needed on the long rods to locate the
back gauge.
12
50
15
15
66
figure 2
figure 3
49
48
figure 4
Advertisement
Table of Contents
