Table of Contents
Advertisement
Adjust the fingers for box and pan bending:
1. Place a thin and flat piece of spacer material (A)
over the notch of the brake die. This flat surface will
help you obtain equal finger length.
2. With the handle assembly, lower the fingers so they
are just touching the top of the spacer on the brake
die.
3. Loosen, but do not remove, the six cap screws
(#20) shown in fig 12.
4. Slide the fingers horizontally to the desired position
or rearrange them to get the desired width
combination for your project.
5. Using the handle assembly, lower the fingers to
apply light pressure. Check to make sure each
finger has continuous contact with the spacer.
6. Tighten the six cap screws.
A
23
23
20
figure 12
Advertisement
Table of Contents
