Baileigh Industrial SBR-3020 Operator's Manual page 20

5. Rotate the handlebar to begin the cut. The shearing
action begins at the left side of the piece part and
continues to the right until the cut is complete.
• The pressure plate (#63) should make contact
with the sheet before the blade (#46) does. If it
does not, adjust the two hex bolts (#17) on the
pressure plate brackets to lower the pressure
plate. When fully open the gap should not
exceed 0.125" (3.175mm).
6. Carefully lift the cut piece from the rear of the
machine if it does not fall to the tabletop or floor on
its own.
Spring Loaded
Hold down
Upper
Shear Blade
Side Guide
Work Apron
18
18
17
46
figure 6
Lower
Shear Blade
63