Table of Contents
Advertisement
Idler Roller
Adjustment
Knob
7. Back the piece out, turn the piece part and repeat the sequence for the other end. See view
"C" below.
8. Now that you have a pre-bend on both ends, it is time to roll the final diameter.
9. Back down the rear idler roll and start rolling the piece forward and reverse as shown in view
"D".
10. Start raising the idler roll gradually and continue rolling the piece forward and reverse until
you have reached the finished diameter.
Note: To achieve a cone configuration, adjust the idler roll on one end only.
Handlebar
Rotation
figure 14
C
figure 15
26
26
D
Advertisement
Table of Contents
