Determining System Configuration - Simrad AP50 Installation Manual

Simrad AP50 Autopilot

2.4 Determining System Configuration

4
5. Select the dockside settings and perform tests (see page 51)
a) Master operation
b) Boat type selection
c) Boat length selection
d) Drive unit voltage selection.
e) Rudder calibration
f) Automatic rudder test
g) Rudder limit
h) Rudder deadband
i) Thruster type (optional)
6. Interface set-up for Distribution Unit, GI51 and NI300X (if
installed; see page 59)
7. Select the settings in the User Set-up Menu for Speed source,
Compass source, and Nav. source. Ref. AP50 Operator
Manual.
8. Perform the autopilot pre-tests at the dock (refer to Operation
Instructions in the AP50 Operator Manual)
a) Test all units (if applicable) - lock/unlock - active/inactive
b) Test the Non-Follow-up mode
c) Test the Follow-up mode
d) Test the AUTO mode
e) Test the AUTO-WORK mode
f) Test the NAV mode and input the interfaces (if
connected), including optional heading sensors
g) Test NAV-WORK mode
h) Test the interface outputs to the external equipment (if
connected)
9. Select the Sea trial settings (see page 66)
a) Compass calibration
b) Compass offset adjustment
c) Thruster adjustment (if connected)
d) Speed source
e) Set cruising speed
f) Set rudder zero
g) Set rate of turn (important)
h) Manual tuning
i) Automatic tuning
j) Speed response
10.Testing the autopilot operation at sea (refer to Final Test on
page 77)
11.Provide the user with training (see page 78)
It is important to become familiar with the configuration of the
system prior to beginning the installation. The AP50 Plus
system with options is shown in Figure 2-1 on page 5.
20222410 / B