Important Safety Instructions; Conventions; Quality And Warranty - Studer VarioTrack VT-40 User Manual

Studer Innotec SA
VarioTrack
2.2 I
MPORTANT SAFETY INSTRUCTIONS
This manual contains important safety instructions. Read carefully the safety and operation
instructions before using the VarioTrack. Take into consideration all the warnings mentioned both on
the equipment and in this manual following all the instructions regarding the operation and use.
For clarity's sake, in this manual the equipment is called VarioTrack, unit or equipment when the
operation description applies either to the VT-40, VT-65 or VT-80 model.
This user manual is intended to serve as a guideline for the safe and efficient use of the VarioTrack.
Anyone who installs or uses a VarioTrack can completely rely on this user manual and is bound to
observe all the safety instructions and indications herein.
This manual does not contain any information meant for persons other than the personnel qualified
for the installation of such a product.
The installation and commissioning of the VarioTrack must be entrusted to qualified personnel. The
installation and use must comply with the local safety instructions and standards in force in the
country.
2.3 C
ONVENTIONS
This symbol is used to indicate safety instructions, which, if not followed, could result in serious
personal injury or death to the operator or the user.
This symbol is used to indicate a risk of material damage and/or the cancellation of the
guarantee.
This symbol is used to indicate a procedure or function that is important for a safe and
correct use of the equipment. Failure to respect these instructions may lead to the
cancellation of the guarantee or to a non-compliant installation.
This symbol placed on the product indicates that its surfaces may reach temperatures
higher than 60°C.
This symbol placed on the product indicates that its use must follow the instructions in the
user's manual.
In general, values important for the operation of the equipment (for example: battery voltage during
absorption) are not mentioned and the parameter number is indicated in the following format:
{xxxxx}. The value of the parameter can be found in the table chap. 15.
In most cases, these values can be modified with the remote control RCC-02/-03 (see chap. 9.1).
The parameter table available at the end of this manual (p. 48) must be kept updated in
case the parameters are modified by the operator or the installer.
If an authorised person modifies a parameter not included in the list (advanced
parameters), the number of the modified parameter(s), the specifications of the
parameter(s) and the new value set are to be indicated at the end of the table.
All the values that are not followed by a parameter number may not be modified.
All digits and letters indicated in brackets or in square brackets in the text of this manual refer to items
represented in illustrations with a circle.
2.4 Q
UALITY AND WARRANTY
During the production and assembly of the VarioTrack, each unit undergoes several checks and tests
which strictly comply with established procedures. The manufacturing, assembling and testing of
each VarioTrack are completely carried out in our factory in Sion (CH). The warranty for this
equipment depends upon the strict application of the instructions in this manual.
6 V 4.0 User manual