Description Of The Variotrack Parameters; Convention; Parameter Access Level; Organisation Of The Configuration Menu - Studer VarioTrack VT-40 User Manual

Studer Innotec SA
VarioTrack
battery, this setting is retained even when the equipment is disconnected from its voltage source
(battery or PV).
8.4 D
ESCRIPTION OF THE
The parameters of the VarioTrack can be modified in the menu "VarioTrack MPPT settings" of the RCC
remote control.
This menu allows accessing the following 3 under-menus:
BASIC SETTINGS: where the most common parameters to be set when commissioning are found.
BATTERY MANAGEMENT AND CYCLE: where all the parameters can be set, defining in detail the
battery cycle during all its phases.
SYSTEM MENU: gathering a few parameters that are not directly related to the battery cycle, such as
backing up and restoring the system, resetting, monitoring setting, etc.

8.4.1 Convention

Functions and values of the parameters mentioned in this manual are described in this chapter. Each
parameter is defined by a short description, a number {xxxxx} followed by its value and unit by default
(xxxxx). The type of parameter (menu, signal) replaces the value between brackets when this latter
does not exist. The RCC menus are also identified by a name and a number {xxxxx} that can be
found, as per the parameter number, on the top right-hand corner of the RCC screen.

8.4.2 Parameter access level

All the parameters described hereafter are accessible through 2 different access levels. In factory
configuration, only a few of them are accessible through the "basic menu". To access all the other
menus and parameters, the RCC must be configured at the "Expert" level following the procedure
given in the RCC manual, chapter "
Each parameter can be placed at a different level (for example, from level "Expert" to level "Basic").
In this case, the parameter is accessible also when the RCC is set to basic mode. For more information
on this subject, refer to chapter "I

8.4.3 Organisation of the configuration menu

Level Nr VarioTrack parameter description
Basic 10000 BASIC SETTINGS
Expert 10054 Block manual programming (dip-switch)
Basic 10001 Voltage of the system
Basic 10037 Synchronisation battery cycle with Xtender
Basic 10005 Floating voltage
Basic 10009 Absorption voltage
Basic 10017 Equalization allowed
Basic 10021 Equalization voltage
Basic 10056 Restore default settings
Inst. 10057 Restore factory settings
Expert 10344 CONFIGURATION OF BIDIRECTIONAL MODE
Expert 10345 Choice of Charger or Boost mode
Expert 10003 BATTERY MANAGEMENT AND CYCLE
Basic 10037 Synchronisation battery cycle with Xtender
Expert 10002 Battery charge current
Expert 10334 Battery undervoltage
Expert 10036 Temperature compensation
Expert 10004 Floating phase
Basic 10005 Floating voltage
Expert 10006 Force phase of floating
Expert 10007 Absorption phase
Expert 10008 Absorption phase allowed
30
V T
ARIO RACK PARAMETERS
" (p. 22).
USER LEVEL
,
NSTALLER LEVEL OF USE AND ACCESSIBILITY
V 4.0
" p.39 in the RCC manual.
Factory value
No
Automatic
Yes
13.6/27.2/54.4 Vdc
14.4/28.8/57.6 Vdc
No
15.6/31.2/62.4 Vdc
Charger
Yes
80 Adc
10/20/40 Vdc
-3 mV/°C/cell
13.6/27.2/54.4 Vdc
Yes
User manual
-
-
-