Table of Contents
Advertisement
Available languages
Available languages
Studer Innotec SA
VarioTrack
8.4.10.5
Reset les compteurs de production solaire journaliers {10043} et
8.4.10.6
Reset les min-max journaliers {10044}
These parameters allow you to reset to zero the different corresponding daily meters. This could be
useful if you wish to know these values precisely over a specific period of time.
8.4.10.7
Restore default settings {10056} (signal)
This signal will restore the initial parameters of the VarioTrack.
If the installer made specific setting at commissioning, this function will restore these settings
instead of the factory settings.
8.4.11
Auxiliary contacts 1 {10088} and 2 {10142} (menu)
When connected to the ARM-02
module (see chap. 9.3 – p. 43),
the
solar
charge
VarioTrack has two additional
external
auxiliary
relays
potential-free
dry
contacts. These two relays make it
possible
to
realize
functions
with
appropriate
cabling
and
programming.The
programming
of
each
contact
independently apart from when a
function requires two relays. In this
case the programmed events for
activating the second relay are
automatically deactivated. The
auxiliary contacts are activated
and deactivated with a 2-second
delay to avoid too frequent
switching.
The auxiliary contacts react to
different
types
of
graphically illustrated below. Basic events that activate the contacts are:
•
Simple events
•
Scheduled events
•
Levels
In the following descriptions, each parameter has two reference numbers. The reference number on
the left refers to the auxiliary contact 1 and the reference number on the right refers to the auxiliary
contact 2. ({reference auxiliary contact 1} {reference auxiliary contact 2}).
8.4.12
Simple functions
8.4.12.1
Switching mode {10089} {10143} (Automatic)
The auxiliary contact can be controlled in 4 different ways:
Manual ON: in this mode, the contact is permanently activated "ON" whatever the external
conditions or programming.
Manual OFF: in this mode, the contact is permanently deactivated "OFF" whatever the external
conditions or programming.
Automatic: in this mode the auxiliary contact is activated according to the conditions and restrictions
of its programming.
Reversed automatic: in this mode, the conditions and restrictions define the deactivation of the relay.
38
controller
with
reversing
multiple
simple
is
made
signals,
V 4.0
User manual
Advertisement
Chapters
Table of Contents
