Installing Guide Bar And Saw Chain - Fieldmann FZP 25410-B Manual

EN 10

Installing Guide Bar and Saw Chain

4. INSTALLING GUIDE BAR AND SAW CHAIN
A standard saw unit package contains the items as illustrated.
Bar protector
Guide bar
Saw chain
Open the box and install the guide bar and the saw chain on the power unit as follows:
WARNING! The saw chain has very sharp edges. Use thick protective gloves for safety.
1. Puli the guard towards the front handle to check that the chain brake is not engaged.
2. Loosen the nuts and remove the chain cover.
3. Install the attached spike to the power unit.
4. Gear the chain to the sprocket and, while fi tting the saw chain around the guide bar, mount the guide bar to
the power unit. Adjust the position of chain tensioner nut on the chain cover to the lower hole of guide bar.
NOTE: Pay attention to the correct direction of the saw chain.
Moving direction
5. Fit the chain cover to the power unit and fasten the nuts to fi nger tightness.
6. While holding up the tip of the bar, adjust the chain tension by turning the tensioner screw until the tie straps
just touch the bottom side of the bar rail.
Power unit
(1) Hole
(2) Tensioner nut
(3) Chain cover
Plug wrench
Screwdriver for carburetor adjustment
Spike and mountaing screws
FZP 25410-B