Table of Contents
Advertisement
The fuel used for this tool is a mixture of unleaded gasoline and registered engine lubricant. When mixing
gasoline with oil, use only gasoline that does not contain ethanol or methanol.
Unleaded gasoline is a quality gasoline type. This will help to avoid damaging the fuel lines of the engine and
other engine parts.
The recommended mixing ratio is 40:1 (make sure the mixing ratio is correct before fi lling the product.
a. Mixing
• Mix in a clean, empty container (supplied).
• Pour the oil into the container.
• Pour the fuel into the tank. Mix the mixture long enough (more than one minute) to get a good
combination.
b. Filling the fuel tank
• Unscrew the fuel tank cap and remove it.
• Fill the tank slowly with the mixture. Do not exceed the maximum capacity (fi ll to 80% of its capacity
preferably).
• Replace the cap on the fuel tank and tighten it
• Wipe any spillage around the unit if necessary
Note: To avoid damage and accidents, DO NOT USE OTHER MIXTURES AND OTHER TYPES OF OIL / PETROL
c. Storage of fuel
The fuel must be kept in a clean and safe container and always closed.
If you are not using the product for a long time, remove the fuel mixture and add it to a container.
Do not leave the fuel for a long time in the product. The fuel may clog the carburetor and the engine will not
operate properly.
d. Disposal of fuel
When the fuel is no longer used or worn, please dispose of it in an authorized location. Check local laws
regarding disposal of fuels
CHAIN SAW
Filling the oil tank and fuel tank
15
EN
USER'S MANUAL
Advertisement
Table of Contents
