Checking The Oil Supply; Adjusting The Carburetor - Fieldmann FZP 25410-B Manual

6. When engine has ignited, fi rst push in the choke knob to the fi rst-stage position and then pull the starter
again to start the engine.
7. Allow the engine to warm up with the throttle lever pulled slightly.
WARNING! Keep clear of the saw chain as it will start rotating upon starting of engine.

CHECKING THE OIL SUPPLY

WARNING! Make sure to set up the bar and the chain when checking the oil supply. If not, the rotating
parts may be exposed. It is very dangerous.
After starting the engine, run the chain at medium speed and see if chain oil is scattered off as shown in the
fi gure.
The chain oil fl ow can be changed by inserting a screwdriver in the hole on bottom of the clutch side. Adjust
according to your work conditions.
NOTE: The oil tank should become nearly empty by the time fuel is used up. Be sure to refi ll the oil tank every
time when refueling the saw.

ADJUSTING THE CARBURETOR

(1) L needle
(2) H needle
(3) Idle adjusting screw¨
The carburetor on your unit has been factory adjusted, but may require fi ne tuning due to a change in operating
conditions.
Before adjusting the carburetor, make sure that the provided air/fuel fi lters are clean and fresh and the fuel
properly mixed.
When adjusting, take the following steps:
NOTE: Be sure to adjust the carburetor with the bar chain attached.
CHAIN SAW
Chain oil
Chain oil fl ow adjusting
Operating the Engine
USER'S MANUAL
13 EN