Release Of The Chain Brake; Checking The Lubrication Of The Chain; Release Of A Jammed Saw; Cutting Work - Fieldmann FZP 25410-B Manual

Table of Contents

RELEASE OF THE CHAIN BRAKE

To use the chain saw again, the chain brake must be released. This must be done machine off and cooled. Pull

the shield until it returns to its original position.

Before checking the oil, make sure that the bar and the chain are in place.

Once the engine is started, turns it at medium speed and checks that the chain oil is sprayed and traces off

the ground.

The oil ﬂ ow of the chain is adjustable to obtain the proper ﬂ ow. Insert a screwdriver on the clutch side.

Turn the adjuster to obtain the correct ﬂ ow rate for the job.

The chainsaw must essentially consume the contents of the oil tank between each full of fuel. Do not forget

to ﬁ ll the oil tank when ﬁ lling the machine with fuel.

If the saw gets stuck during cutting, the operators should:

Saw the saw and attach it securely to the cutting foot of the shaft (ie trunk side) or has a separate chord from

the tool

Pull the saw of the cluster while the branch is lifted, if necessary,

If necessary, use a hand saw or a second chainsaw to release the chain saw.

The tool should only be used to cut trees. Do not use it for other applications.

Do not attempt to remove the chainsaw when it is stuck during operation. Stop the machine and remove the

wedge blade with a wedge.

Stick your feet well, keep a good balance and do not climb on the tree trunk.

Try not to work on a slope. However, if you have to work on a slope, always stand higher than the tree trunk.

Before bending a branch or trunk in bending, observe the direction of bending and ﬁ nish the cut opposite the

bending side to prevent the chain guide from getting stuck in the cut.

Examine the work area and estimate where the tree will fall. Start the machine as described above. Start by

making a notch in the direction of fall chosen.

When the tree falls, shout or make a beep to alert people in the vicinity. When the shaft falls, move away from the

cutting area.

CHAIN SAW

Operation

USER'S MANUAL

Table of Contents