Operating The Engine; Starting The Engine - Fieldmann FZP 25410-B Manual

EN 12

Operating the Engine

5. OPERATING THE ENGINE
WARNING! It is very dangerous to run a chainsaw that mounts broken parts or lacks any parts.
Before starting engine, make sure that all the parts including bar and chain are installed properly.

STARTING THE ENGINE

1. Fill fuel and chain oil tanks respectively, and tighten the caps securely.
2. Set the switch to T position.
3. While holding the throttle lever together with the throttle interlock, push in the side latch and release the
throttle lever to hold it at the starting position.
4. Puli out the choke knob to the closed position.
Choke knob
NOTE: When restarting immediately after stopping the engine, set the Choke knob in the fi rst-stage position
(choke open and throttle lever in the starting position).
NOTE: Once the choke knob has been pulled out, it will not return to the operating position even if you press
down on it with your fi nger. When you wish to return the choke knob to the operating position, pull out the
throttle lever instead.
5. While holding the saw unit securely on the ground, pull the starter rope vigorously.
WARNING! Do not start the engine while the chain saw hangs in one hand. The saw
chain may touch your body. This in very dangerous.
(1) Chain oil
(2) Fuel
(1) Switch
(2) Latch
(3) Throttle lever
(4) Throttle interlock
FZP 25410-B