Table of Contents
Advertisement
Installation
Split Wood Kit 1505SWKV2
Material required
• Black steel platform (supplied with appliance)
• Split Wood Kit, which contains:
• 9 logs
• 1 bag of grey embers, 6 cups
• Gloves, if desired, not supplied
22
28
21
24
Note
Use of V2 log sets may increase the possibility of
soot formation when the air shutter is closed. The
L1 units are fitted with an air shutter stopper to
prevent closing the aeration completely in order
to prevent sooting in most situations. However, it
is still possible that some sooting may occur under
certain conditions.
Evaluate the flame picture carefully after the unit
has warmed up for fifteen minutes, and avoid
closing the air shutter completely when there is
limited rise in the venting system or the flame
appears overly luminous and lazy with smoke
trailing off the flame tips.
Refer to "Checking Operation and Aeration" on
page 57 for details about aeration adjustment.
26
20
23
25
27
Installation
1. Carefully unpack the kit. Note each log has its own
number stamped on the bottom. Some logs have
pegs to help you place them on other logs or the
platform.
2. Install the logs as follows.
3. Install the steel platform around the burner as
indicated. The openings in the platform should be
underneath.
Installed platform
4. Place log 21 as shown with the pin in the hole.
21
5. Place log 22 from on top of log 21, across the burner
to the front platform.
22
21
Fuel Beds
49
Advertisement
Table of Contents
