Table of Contents
Advertisement
7.8. DISASSEMBLING THE HANDLEBARS
Figure 7.8-1
Figure 7.8-2
Page 7.8
ROTEX XT: Service & Maintenance Manual - rev. 1.0
1. Turn off the machine and unplug the mains
lead from the wall output.
2. Unscrew the 2 screws a fixing the CENTER
HANDLEBAR using an 8-mm hex T wrench.
3. Remove the CENTER HANDLEBAR.
To
disassemble
HANDLEBARS:
4. Carry out the procedure described in
paragraph 7.6. "Disassembling the upright
guard".
5. Unscrew the two upper fixing screws b of the
SIDE HANDLEBAR using a 6-mm hex T
wrench.
6. Unscrew the lower fixing screw c of the
SIDE HANDLEBAR using a 6-mm hex T
wrench.
7. Remove the SIDE HANDLEBAR.
To reassemble the HANDLEBARS, carry out the
above steps in reverse order.
each
of
the
SIDE
Advertisement
Table of Contents
