Routing Of Cables - Technogym Rotex XT Service Maintenance Manual

• the coil must be positioned well away (even a few centimeters) from the LEDs;
• the cable must be folded immediately after the connection on the receiver, so that it does not pass
near the coil;
• the receiver must be directed in such a way that its axis of reception is parallel to that of the
transmitter, as shown in the figure below:
Please note that even small departures from the above specifications may considerably impair the
accuracy of reception.
The optimal configuration is therefore that shown in the figure below:
11.1.6. R
OUTING OF CABLES
Particular care must be taken in the routing of cables to prevent interference with the receiver coil.
Therefore, and particularly in the version with the receiver housed inside the display, it is
recommended to:
• Route cable BK-7 behind the studs which fix display on its support, and not on top of the CPU
board;
• The TGS cable, if present, must be routed behind connector CN1 on the CPU board to ensure
that it does not go near the receiver coil when the display is closed.
Page 11.4
ROTEX XT: Service & Maintenance Manual - rev. 1.0
Figure 11.1-2
Figure 11.1-3