ROTEX XT: Service & Maintenance Manual - rev. 1.0
8. ADJUSTMENTS
8.1. BELT ALIGNMENT
Figure 8.1-1
Carry out the procedure described in paragraph
7.7. "Disassembling the frame guards".
1. Back off the lock nut a on the alternator
pivot b using a 19-mm wrench.
2. Back off locking dowel c of alternator pivot b
using a 4-mm hex T wrench.
3. Placing a straight reference rod d against
pulley e, check that the reference rod d is
parallel with belt f.
4. Adjust alternator pivot b: screwing or
unscrewing causes the alternator to move
forward or backward along the pivot axis.
5. After completing the adjustment, lock down
the dowel c on alternator pivot b and tighten
the lock nut a.
After completing this procedure, check
the
belt
tension
paragraph 8.2. .
as
described
in
Page 8.1