Table of Contents
Advertisement
5.2. DISASSEMBLING THE WEIGHT STACK
Figure 5.2-1
Figure 5.2-2
Figure 5.2-3
Figure 5.2-4
Page 5.2
All manuals and user guides at all-guides.com
ELEMENT LINE: Service & Maintenance Manual - rev. 1.2
Carry out the procedure described in paragraph
5.1. "Weight stack casing".
1. Back off the screws (a), using a 5-mm hex
2. Remove the weight stack casing support.
3. For both the weight stack rods, back off the
4. Use a 4-mm hex wrench to back off the grub
5. Back off the counter nut (e) and then the
6. Push the rods toward the back in order to
To reassemble the weight stack, carry out the
wrench.
grub screws which secure the rods, reaching
them by the two holes (c) in the shock
absorbers. Use a 4-mm hex wrench.
The rod will move down by a few
centimetres.
screws (d) and remove the stop from both the
rods.
threaded pin (f), using a 22-mm wrench.
remove, from the top, all the plate of the
weight stack, additional weight assembly if
present.
above steps in reverse order.
After complete this procedure, adjust
the
cable
tension
paragraph 6.2. "The weight stack cable
is not taut".
as
detailed
in
Advertisement
Table of Contents
