Delta VFD004L11A User Manual page 30

Send Quote Requests to info@automatedpt.com
VFD-L Series
From the above table, we see that the carrier frequency of PWM output has a significant
influence on the electromagnetic noise, heat dissipation of the AC drive, and the acoustic
noise to the motor.
2 - 04 Reverse Operation Inhibit
Settings
The parameter determines whether the AC drive can operate in the reverse or forward
directions.
2 - 05 Loss of ACI Input
Settings
This parameter is only effective when the Source of Frequency is commanded by a 4 to
20 mA signal. The ACI input is considered lost when the ACI signal falls below 2 mA.
2 - 06 Line Start Lockout
Settings
When enabled, the AC drive wil not start when powered up with run commands applied.
To start in Line Start Lockout mode, the AC drive must see the run command go from
stop to run after power up. When Line Start Lockout is disable (also known as
Auto-Start), the drive will start when powered-up with run commands applied.
d 0 enable Reverse operation
d 1 disable Reverse operation
d 2 disable Forward operation
d 0 Upon the loss of ACI, the drive will default to an output
frequency of 0 Hz.
d 1 Upon the loss of ACI, the drive will stop and display error
message "EF".
d 2 Upon the loss of ACI, the drive will continue to run at the
last known ACI input.
d 0 enable
d 1 disable
Send Quote Requests to info@automatedpt.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
5-12
DELTA ELECTRONICS, INC. ALL RIGHTS RESERVED
Factory Setting: d 0
Factory Setting: d 0
Factory Setting: d 0