Group 2: Operating Method Parameters - Delta VFD004L11A User Manual

Send Quote Requests to info@automatedpt.com
VFD-L Series
Group 2: Operation Method Parameters
2 – 00 Source of Frequency Command
Settings
This parameter sets the Frequency Command Source of the AC drive.
If the Frequency Command Source is external (DC 0 to +10V or 4 to 20mA), please
select DC voltage signal or current signal.
2 - 01 Source of Operation Command
Settings
When the AC drive is controlled by an external source, please refer to parameter group 4
for detailed explanations on related parameter settings.
2 - 02 Stop Method
Settings
d 0 Master Frequency input determined by digital keypad.
d 1 Master Frequency determined by analog signal DC 0V-10V
(external terminal AVI).
d 2 Master Frequency determined by analog signal DC 4mA -
20mA (external terminal AVI).
d 3 Master Frequency determined by Potentiometer on the
digital keypad.
d 4 Master Frequency operated by RS-485 serial
communication interface.
J 1
Vo lta g e s ig n a l in p u t(0 - 1 0 V )
C u r re n t s ig n a l in p u t(4 -2 0 m A )
d 0 Controlled by the keypad
d 1 Controlled by the external terminals, keypad STOP
enabled.
d 2 Controlled by the external terminals, keypad STOP
disabled.
d 3 Controlled by the RS-485 communication interface,
keypad STOP enabled.
d 4 Controlled by the RS-485 communication interface,
keypad STOP disabled.
d 0 Ramp stop
d 1 Coast stop
Send Quote Requests to info@automatedpt.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
5-10
DELTA ELECTRONICS, INC. ALL RIGHTS RESERVED
Factory Setting: d 0
Factory Setting: d 0
Factory Setting: d 0