Canon TM-355 Online Manual page 388

Hide thumbs Also See for TM-355:

Table of Contents

• When Detected size is selected for Detect image size and Enable is selected for Oversize:

F: Position of cut

Cut at length of upper and lower margins added to length of minimum image range detected.

TM-350/TM-340/TM-250/TM-240/TM-5350/TM-5340/TM-5250/TM-5240

• When OFF or Command priority is selected for Detect image size and Disable is selected for

First, determine the image drawing range based on the Detect image size setting, and then perform the

processing when Disable is selected for Oversize.

Since margins are added inside the image drawing range, images may be chipped depending on the

• When OFF or Command priority is selected for Detect image size and Enable is selected for

First, determine the image drawing range based on the Detect image size setting, and then perform the

processing when Enable is selected for Oversize.

Since margins are added outside the image drawing range, images will not be chipped due to the

However, you will need to print on paper that is larger than the size of the image drawing range

determined based on Detect image size setting, plus the top, bottom, left and right margins.

• Not all HP-GL/2 data can be supported.

Troubleshooting