Table of Contents
Advertisement
13.
13. Holding the roll holder flange (A), guide the holder along the slide guides (B) on both ends,
keeping the holder level as you load it in the roll holder slot.
Caution
•
• Do not force the roll holder into the printer with the right and left ends reversed. This may damage
the printer and roll holder.
•
• Do not release the flanges until the holder is loaded in the roll holder slot.
•
• Be careful not to pinch your fingers between the slide guides (B) and the roll holder shaft (C) when
loading rolls.
Important
•
• If the leading edge of the roll paper is cut crooked or folded, it may not be fed correctly. Cut the
leading edge of the roll paper with scissors or the like and straighten it.
• Load the roll paper so that it is not loaded in the opposite direction.
•
•
• If the roll paper has become unwound, remove the slack before loading the roll paper.
•
• If the paper is wrinkled or warped, straighten it out before loading it.
•
• Load the roll so that there is no gap between the right edge of the roll paper and the roll holder.
207
Advertisement
Table of Contents
Troubleshooting
