Canon TM-355 Online Manual page 190

3mm
Prints in standard-size.
Choose this setting if there are no particular problems when printing.
20mm
Choose this setting in case of chafing against the print head, for example when using significantly
curled paper.
Cut Speed
Allows you to select the speed of automatic cutting. Use it to adjust the automatic cutting function when
clean cutting is not possible.
Printer Default
Applies the settings configured in operation panel of the printer.
Fast
Choose this if clean cut surfaces are not possible with the Standard setting.
Standard
Choose this if there are no particular problems with automatic cutting.
Slow
Choose it when using adhesive paper in order to prevent the glue from sticking to the cutter and to
avoid a drop in cutting performance.
Automatic Cutting
You can set whether to have the paper cut automatically or to have cut lines printed on the paper.
The following settings can be configured for automatic cutting.
Yes
Applies the settings configured in the operation panel of the printer unit.
None
After printing is over, the printer goes on to print the next set of data without cutting the paper into
individual pages.
Print Cut Guideline
After printing is over, the printer prints cutting lines on each page and goes on to print the next set
of data.
Unidirectional Printing
Suppresses uneven coloring and line shifts during printing.
To perform unidirectional printing, check this check box.
Calibration Value
Allows you to apply the results of calibration performed on the printer. To apply the calibration values,
select Use Value.
190