Port Option Sets - Paradyne 3610 Application Manual

Port Option Sets

The Prt1 through Prt6 selections allow configuration
options to be set on a per-port basis for TDM, MCMP, or
Bridge mode.
In TDM or MCMP mode, the Prt1 through Prt6
selections are available. In Bridge mode, the Prt2 through
Prt6 selections are available; selections for Prt1 are set
via the DSU and Gen submenus (option sets).
Change MUX Opts:
Copy Setup
F1 F2
Prt2 Prt3 Prt4
In a port path, you are presented with the configuration
options listed in Table 5-10. In this table, the
configuration options with an X for a particular mode are
valid for the mode selected. A configuration option
without an X either does not appear in that mode, is forced
to a certain value, or has no meaning for that mode. For an
option forced to a certain value, all of the values normally
available to that option still appear, but changes made
have no effect; the configuration option's value is not
overwritten in software.
The Copy selection allows the set of configuration
options that have been specified for a port to be copied
into another port, or into all other ports. There are two
menus associated with Copy: Copy from and Copy to.
3610-A2-GB41-70
Prt1
F3
Prt5 Prt6
July 1999
To access the Copy from menu,
Change MUX Opts:
Copy Setup
F1 F2
Prt2 Prt3 Prt4
Copy from:
Prt1 Prt2
F1 F2
Prt2 Prt3 Prt4
The Prt1 selection in the Copy from menu appears in
TDM or MCMP mode (shown above), but not in Bridge
mode. Select a port (for this example, Port 3 is selected).
The Copy to menu appears.
Copy Prt3 to:
All Prt1
F1 F2
Prt2 Prt3 Prt4
If All is selected, a set of Prt3 configuration option
values will be written to each port: Prt1 through Prt6 in
TDM or MCMP mode, and Prt2 through Prt6 in Bridge
mode. If a port is selected, the Prt3 configuration option
values will only be written to the selected port.
DSU Operations
Prt1
F3
Prt5 Prt6
Prt3
F3
Prt5 Prt6
Prt2
F3
Prt5 Prt6
5-37