Model 3611 Installation; Overview - Paradyne 3610 Application Manual

Overview

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Non-Modular DSU with a TDM or MCMP
Modular DSU with a TDM or MCMP
DBM-Vs/DBM-Ss/DBM-Ds
Hardware Straps
Software Configuration
From the SDCP
From the NMS
Verification Testing
Adding a TDM or MCMP to an Installed Model 3611 DSU
Installing a Non-Modular TDM or MCMP
Power-Up Routine
Installing a Modular TDM or MCMP
Removing a TDM or MCMP from an Installed Model 3611 DSU
Overview
The Model 3611 DSU-TDM or DSU-MCMP is
designed for installation in a COMSPHERE 3000 Series
Carrier, which supplies operating power and provides
interfaces for connecting to the DDS and, if required,
analog networks. Up to 16 DSUs can be installed in a
COMSPHERE 3000 Series Carrier.
A Model 3611 DSU (modular or non-modular) is
delivered with default strap settings and factory-installed
software options. The DSU is ready to connect to the
network and is configured as a control DSU for operation
at 9.6 kbps on a point-to-point circuit, with diagnostic
protocol set to ADp. When a TDM or MCMP is installed,
Port 1 of the DSU is configured to operate at 9.6 kbps
with the TDM or MCMP capability enabled; all other
ports are disabled.
NOTE
In this guide, Model 3611 refers
to either the modular or the
non-modular DSU-TDM or
DSU-MCMP, unless otherwise
specified.
3610-A2-GB41-70

Model 3611 Installation

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
A shared diagnostic control panel (SDCP), installed in
the carrier, is required for installation and maintenance of
the Model 3611 DSU-TDM or DSU-MCMP.
Installation of the DSU-TDM or DSU-MCMP and
carrier-related equipment consists of the following
procedures, which should be performed in the order listed.
Changing hardware straps (if necessary)
Physical installation of the DSU-TDM or
DSU-MCMP
Network diagnostic connection
Software configuration
DDS network (or LADS) connection
PSTN or switched 56 kbps network connection
(if a DBM is installed)
DSU DTE connection
Operation verification
This chapter tells you how to perform the procedures.
For electrical connection, network diagnostic connection,
PSTN and switched 56 kbps network connection, DDS
network or LADS connection, and DSU DTE connection
information, refer to the COMSPHERE 3000 Series
Carrier, Installation Manual.
July 1999
3
3-1
3-2
3-2
3-2
3-3
3-4
3-4
3-4
3-5
3-6
3-7
3-8
3-10
3-13
3-1