Mux Setup Option Set - Paradyne 3610 Application Manual

The Load from submenu displays the following
selections:
SAVE DSU DBM
E d i t / S a v e:
Gen Bkup
F1 F2
PrtSp
Press the key to scroll the SAVE, DSU, and DBM
selections into view; press the
selection into view. Select MUX and the following
appears:
Chang MUX Opts:
Copy Setup
F1 F2
Prt2 Prt3 Prt4
With the Copy selection, configuration options set for
one port can be copied over to either a single port or to all
other ports. The Setup selection allows the TDM or
MCMP to be disabled (enabling Basic mode), or the TDM
or MCMP to be enabled (enabling TDM or MCMP mode,
or Bridge mode). Selections Prt1 through Prt6 allow
configuration options to be set on a per-port basis.

MUX Setup Option Set

Press the F2 key to select the mode of operation and
access the MUX Setup submenu.
Chang MUX Opts:
Copy Setup
F1 F2
Prt2 Prt3 Prt4
3610-A2-GB41-70
MUX
F3
key to scroll the PrtSp
Prt1
F3
Prt5 Prt6
Prt1
F3
Prt5 Prt6
July 1999
The Setup selection displays the first configuration
option in the Setup option set, MUX Funct, which is
shown below and which selects the DSU-TDM's or
DSU-MCMP's mode of operation.
MUX Funct: MCMP
Next TDM MCMP
F1 F2
CBrdg EBrdg
Select the DSU-TDM's or DSU-MCMP's mode of
operation by making one of the following selections:
TDM mode – Set MUX Funct to TDM.
MCMP mode – Set MUX Funct to MCMP. (This
mode is only available to a DSU-MCMP.)
Bridge mode – Set MUX Funct to CBrdg for the
TDM or MCMP circuit card to operate as a
central-site bridge, or to EBrdg for the TDM or
MCMP circuit card to operate as an extended
bridge.
Basic mode – Set MUX Funct to None to disable
the TDM or MCMP circuit card.
NOTE
Always select the mode (MUX
Funct) first , then set the
configuration options within the
option set. The mode affects the
configuration options that are
available, as well as the values
that are displayed for each.
DSU Operations
F3
None Prev
5-33