Selecting The Number Of Trap Managers; Configuring A Destination For Snmp Traps - Paradyne 3172 Operator's Manual

Selecting the Number of Trap Managers

If you intend to issue traps to an SNMP manager(s)
from this device, you must specify the number of SNMP
managers that are to receive the traps.
To specify the number of SNMP managers to receive
traps from this device:
"
Procedure
1. Press F3 to select Cnfig from the top-level menu
screen.
2. Select the configuration option set to be copied
into the Edit area by using the appropriate
Function key. Use the scroll keys, if necessary.
3. Press F1 to select Edit.
4. Press the key from the Edit screen to display
the SNMP selection.
5. Select SNMP.
Edit:
User
F1
6. Select Trap from the SNMP Config screen.
SNMP Config:
Gen
F1
7. Select the number of SNMP managers to receive
traps (from 1 through 6) by using the appropriate
Function key. Use the scroll keys, if necessary.
Num Trap Mgrs:1
Next
F1
3170-A2-GB20-30
Alarm SNMP
F3
F2
Trap
F2 F3
1 2
F2 F3

Configuring a Destination for SNMP Traps

A destination must be configured for each SNMP trap
manager specified. This configuration option is displayed
for the number of trap managers specified by the Number
of Trap Managers configuration option.
To configure an IP address for the SNMP trap
manager:
"
Procedure
1. Press F3 to select Cnfig from the top-level menu
screen.
2. Select the configuration option set to be copied
into the Edit area by using the appropriate
Function key. Use the scroll keys, if necessary.
3. Press F1 to select Edit.
4. Press the
the SNMP selection.
5. Select SNMP. (For screen displays, see the
previous section,
Managers.)
6. Select Trap from the SNMP Config screen.
7. Press F1 (Next) until the Trapn IP Address
configuration option appears.
8. Press F2 (Edit) to edit the IP address. You have
the option of using F3 (Clear) to reset the IP
address to the factory default 000.000.000.000.
Refer to the
page 3-15 for more information on setting an IP
address.
9. Press F1 (Next) until the Trapn Destination
configuration appears, and select the destination
for the SNMP trap by using the appropriate
Function key. Use the scroll keys, if necessary.
March 1999
key from the Edit screen to display
Selecting the Number of Trap
Setting the IP Address section on
Trap n Dst:
Next None Com
F1 F2 F3
Operation
3-19