Lamp Test; Starting A Lamp Test - Paradyne 3172 Operator's Manual

4. From the Patterns Abort screen, press the desired
Function key to abort either All active test
patterns, active Send test patterns, or the active
Monitor (Mon) test pattern.
Patterns: Abort
All
F1
If you select All, the E1 DSU/CSU terminates all
active test patterns and displays the message
Command Complete. Skip Step 5.
NOTE
Be careful when selecting a specific
test pattern to abort. If you mistakenly
choose to abort a test pattern that is
not currently running, a Command
Complete message still displays and
the test pattern currently active still
runs. You can use the TStat branch of
the menu to view the test status to
determine if the abort was successful.
5. From the Abort screen, press the Function key that
corresponds to the network or port for which you
want to abort a test pattern. Use the scroll keys, if
necessary.
Abort: Send or Mon
NET
F1
The E1 DSU/CSU terminates the selected test
pattern and displays the message Command
Complete.
3170-A2-GB20-30
Send Mon
F2 F3
Prt1 Prt2
F3
F2

Lamp Test

Use the Lamp Test commands to start and stop a test of
the E1 DSU/CSU front panel LCD and LEDs.

Starting a Lamp Test

To start a Lamp test:
"
Procedure
1. Press F2 to select Test from the top-level menu
screen.
2. From the Test screen, press
the Lamp selection on the screen.
3. From the Test screen, press F3 to select Lamp.
4. From the Lamp Test screen, press F2 to select
Start.
March 1999
once to display
Test:
Rlpbk Lpbk Ptrns
F1 F2 F3
Test:
Lpbk Ptrns Lamp
F3
F1 F2

Lamp Test:

Abort Start
F1 F2 F3
Maintenance
4-23