Displaying Led Conditions - Paradyne 3172 Operator's Manual

ACCULINK 3172 and 3174 E1 DSU/CSU

Displaying LED Conditions

The same conditions monitored by the front panel
LEDs can also be monitored by the LED command. This
command is most useful when the E1 DSU/CSU is being
accessed remotely (see Appendix G,
Emulation). When using Front Panel Emulation, no LEDs
are shown on the PC's screen; you must use the Stat
command procedure described below to get LED
information.
To display LED conditions on the front panel screen:
"
Procedure
1. Press F1 to select Stat from the top-level menu
screen.
DSU E1 CEPT
Stat
F1
2. From the Status screen, press the
display the LED selection.
Status:
DevHS STest
F1
3. Select LED from the Status screen.
Status:
Perf
F1
3-10
Front Panel
Test Cnfig
F2 F3
key to
Perf
F3
F2
TStat LED
F3
F2
4. From the Select LEDs screen, press the Function
key that corresponds to E1 or the port for which
you want to display LEDs. Use the scroll keys, if
necessary.
If you chose E1, the LED Display screen lists the
LED signals, two at a time, on the second line. A
vertical bar at the left of the LED name indicates
the condition is ON, while an underscore indicates
the condition is Off.
If you chose a port, the Port n LEDs screen lists
the LED signals, two at a time, on the second line.
A vertical bar at the left of the LED name
indicates the condition is ON, while an underscore
indicates the condition is Off.
5. Use the
onto the screen.
March 1999
Select LEDs:
E1 Prt1 Prt2
F1 F2 F3
LED Display:
_Test _NetSig
F1 F2 F3
Port n LEDs:
_DTR _TXD
F1 F2 F3
and keys to scroll LED names
3170-A2-GB20-30