Table of Contents
Advertisement
13)
When not in use, return machine to stowed position. Note: Fully lower the Link booms first
(Lever 4) followed by the Upper boom (Lever 5) for smooth operation. Turn the Base/Platform
selector anti-clockwise to the Off position, remove key and chock wheels.
TM
4.3.5
SiOPS
- LOAD SENSING CONSOLE
This machine incorporates a load sensing cage console that senses if the operator has been pushed or
has fallen against the console. If the load applied to the front of the console is greater than the pre-
determined amount, the footswitch will be disabled to increase operator safety and reduce the
possibility of sustained involuntary operation of the cage controls.
Note: The green button will illuminate once the footswitch has been disabled, but continues to be
available for use at all times. This allows the operator to use the cage control functions and
manoeuvre the machine to a safe position.
To reset the footswitch:
1)
Release the load from the front of the console.
2)
Ensure cage controls are in the neutral position and clear of objects.
3)
Raise foot clear of footswitch then lower foot onto footswitch.
4)
Footswitch is now active and full control has been restored.
Note: If SiOPS
warning beacon will flash (If fitted, located on underside of the cage) and a warning
announcement will sound until the footswitch is reset as described previously.
English/USA – 04/15
Original instructions
ALWAYS ENSURE THE AERIAL PLATFORM IS ON A FIRM LEVEL SURFACE AND
THE AREA IS FREE OF ANY OVERHEAD OBSTRUCTIONS.
ENGAGING THE RED EMERGENCY STOP BUTTON WILL SHUT DOWN THE
ENGINE, AND THE ELECTRIC CIRCUIT PREVENTING OPERATION OF ANY
FUNCTION.
WHEN OPERATING THIS MACHINE THE USER MUST BE AWARE OF ANY
OVERHEAD OBSTRUCTIONS.
TM
has been activated and the footswitch is not reset within 15 seconds, then the blue
Height Rider/SP Series
Operating & Safety Instructions
33
Advertisement
Table of Contents
