nifty Heightrider HR28 Series Operating/Safety Instructions Manual page 11

Table of Contents

Advertisement

2.1.8
This machine contains several hazardous substances such as but not limited to: Battery acid, Hydraulic
Fluid, Engine Coolant, Antifreeze, LPG, Diesel Fuel, Petrol, Engine Oil, Grease, and Gasoline.
2.1.9
Covers and canopies should remain closed when the machine is in operation. Only trained personnel
should carry out maintenance on the machine, ensuring at all times they protect themselves from
electrical, heat and mechanical hazards.
2.1.10
Never exceed the maximum platform capacity, as indicated on the decals and machine serial plate.
2.1.11
Only operate the Niftylift on a firm, level surface.
2.1.12
Never position any part of the Niftylift inside the Minimum approach distances (MAD) to above-
ground electrical conductors as listed in the table below. (Reference ISO 18893:2014).
2.1.13
On entering the platform ensure that the drop down entry bar is closed afterwards.
2.1.14
Use of an approved safety belt and lanyard, hard hat and appropriate safety clothing is mandatory.
Fasten harness to designated harness securing points within the platform and do not remove until
leaving the platform whilst in the stowed position.
2.1.15
2.1.16
Do not use the platform levelling system to artificially increase the outreach of the platform. Never use
boards or ladders in the platform to achieve the same result.
2.1.17
Do not use the platform to lift overhanging or bulky items that may exceed the maximum capacity or
carry objects that may increase the wind loading on the platform. (e.g. Notice boards etc.)
2.1.18
The Niftylift shall not be operated from a position on trucks, trailers, railway cars, floating vessels,
scaffolds or similar equipment unless the application is approved in writing by Niftylift Ltd in Great
Britain.
English/USA – 04/15
Original instructions
Voltage range (kV)
<0.7
≥0.7 to 7
>7 to 50
>50 to 220
>220 to 500
>500 to 750
>750 to 1000
>1000 to 1250
THIS MACHINE IS NOT INSULATED.
If in doubt, contact the local appropriate governing authority.
Always remain standing within the platform. Do not attempt to increase your height
or reach by standing and/or climbing on the platform guard rails or any other object.
KEEP YOUR FEET ON THE PLATFORM FLOOR. Do not sit, stand or climb on the
guard rail, mid rail or boom linkage. Use of planks, ladders or any other devices on
the Niftylift for achieving additional height or reach shall be prohibited.
Height Rider/SP Series
Operating & Safety Instructions
MAD (m)
1
1.2
3
4
5
10
13
16
9

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sp85

Table of Contents