Table of Contents
Advertisement
DIESEL
7)
COLD ENGINE: - turn the Diesel Glow/Start selector to the Glow position (anti-clockwise). This
engages the glow plug pre-heat system. Hold for 5-10 seconds then turn the key to the Start
position (fully clockwise) and the engine will fire. However, there is a time delay dependant on
fuel temperature (Refer to table below). For example, if the fuel temperature is -15°C there will
be a delay of 2 seconds after turning the key, before it starts cranking. After the engine has
started it will only operate at idle speed for a further 35 seconds.
Fuel Temperature
(°C)
-25
-20
-15
-10
-5
0
10
20
30
8)
WARM ENGINE: - turn the Diesel Glow/Start selector to the Start position (clockwise) and the
engine will fire.
ALL MODELS
9)
Push and hold green power button on the base control panel.
10)
Select one or more functions and operate the appropriate hydraulic levers in full accordance with
manufacturers operating and safety manual. (Refer to Section 4.2.1)
Note: Move lever until resistance is felt, then push/pull harder to activate function.
11)
To return control to the platform, turn base control key-switch to the Platform position (fully
clockwise).
12)
When not in use, return machine to stowed position. Note: Fully lower the Link booms first
(Lever 4) followed by the Upper boom (Lever 5) for smooth operation. Turn the Base/Platform
selector anti-clockwise to the Off position, remove key and chock wheels.
English/USA – 04/15
Original instructions
Operating & Safety Instructions
Crank delay
Idle delay
(seconds)
(seconds)
2
60
2
50
2
35
2
20
0
15
0
12
0
8
0
5
0
5
Height Rider/SP Series
25
Advertisement
Table of Contents
