Fig 5-19 Type 5 Battery Discharge Figure - Prodigit 34000A Series Operation Manual

5.17.6. CC+CV: Refer to Chapter 5-7 for the operation mode.
5.17.7. CP+CV: Refer to Chapter 5-8 for the operation mode.
5.17.8. Operation：Type 1 to 3 is manual operation or remote operation.
Type 4 to 5 the only Remote operation.
Manual Instructions:
5.17.8.1. Type 1:
When testing loads on of Constant current (CC) mode, Press Config key to Batt1,
Setting parameters Middle LCD text will show "BATT1, It is TYPE 1.Right LCD text
Will show "UVP", adjustment UVP value, Press START Key to start the test at this
Time automatic load on, right LCD text will accumulate the Discharge capacity, unit:
AH (ampere-hour), When the battery Voltage less than the UVP value, Load off Test
End. Right LCD will display total discharge capacity, if you press the START key will
Retest or press any key to exit test status.
5.17.8.2. Type 2:
When testing loads on of Constant current (CC) mode, Press Config key to Batt2,
Setting parameters Middle LCD text will show "BATT2, It is TYPE 2. Right LCD text
Will show "UVP", adjustment UVP value, Press START Key to start the test at this
Time automatic load on; Right LCD text will accumulate the discharge capacity, Unit:
AH (ampere-hour), When the battery Voltage is less than the UVP value, CC Mode
Automatic change to CV mode keep load on and exit test status.
5.17.8.3. Type 3:
When testing loads on of Constant current (CC) mode, Press Config key to Batt3,
Setting parameters Middle LCD text will show "BATT3, It is TYPE 3.Right 5 digit LCD
Display will show "Time", adjustment time value, Press START Key to start the test
At this time automatic LOAD ON, Right 5 digit LCD display will accumulate the
Discharge capacity, when load on time achieve setting time, this moment Load on
Auto change to load off, Right 5 digit LCD display will show End Voltage. If you Press
The START key will retest or press any key to exit.

Fig 5-19 TYPE 5 Battery Discharge Figure

34000A Series Operation Manual 159