Description Of The Displays And Operating Controls; Description Of The Buttons - Ecolab DG 3.1 Operating Instructions Manual

5.3

Description of the displays and operating controls

Fig. 5.3 Displays and operating controls
5.4

Description of the buttons

The buttons have the following functions.
Illustration
Fig. 5.4 Button: START
Fig. 5.5 Button: STOP
and
Fig. 5.6 Button: Up / Down
and
Fig. 5.7 Button: Left / Right
Fig. 5.8 Button: ENTER
417102242_DG_3
On the front of the
keypad, an LC display, and an operation LED.
The display screen shows the operating statuses and current
settings (for example, the concentration) as well as error
messages. You use the membrane keypad to operate and
program the device and to check data.
Meaning Description
In operating mode, the "Start" button is used to start the tapping process
START
of the ready-to-use disinfectant solution.
The "Stop" button interrupts the tapping and is used for acknowledging
STOP
error messages.
Is used in operating mode to input the staff code (if activated) and to
Up / Down
select the tap quantity. In programming mode, they are used for setting or
changing parameters.
Is used in operating mode to switch concentration from 1 to 2 and back or
Left / Right
to view the operating data. In programming mode for switching between
the settings or displays.
ENTER
Used in operating mode to activate the personnel mode
(confirmation)
(if activated) and to exit the operating data view.
Used in programming mode to save values or to activate displays.
DG 3 is a control panel. It has a membrane
- 67 - Rev.: 02-05.2014