Table of Contents
Advertisement
Instruction manual
In order to obtain the CG specified, reposition
the receiver and other equipment.
If not obtain the CG specified, add a weight and
adjust.
Do not fly before confirming the
correct location of the CG. If the
CG is incorrect, you lose control
of your airplane which leads to
accidents.
PRE-FLIGHT CHECK
1) Completely charge your transmitter and
receiver batteries before your first day of flying.
2) Check every bolt and every glue joint in your
plane to ensure that everything is tight and well
bonded.
3) Double check the balance of the airplane.
4) Check the control surface.
5) Check the receiver antenna. It should be fully
extended and not coiled up inside the fuselage.
6) Properly balance the propeller.
HE-111
CG
Aileron control
Elevator
Rudder control
Flap
CONTROL THROWS
We highly recommend setting up a plane using
1)
the control throws listed.
2) The control throws should be measured at the
widest point of each control surface.
3) Check to be sure the control surfaces move in the
correct directions.
Low rate:
12
Aileron:
mm up
14
Elevator
m m up
25
Rudder:
mm right
25
Flap:
mm
High rate:
14
Aileron:
mm up
16
Elevator:
mm up
30
Rudder:
mm right
35
Flap:
mm
Item code: BH184
12mm
12mm
14mm
14mm
25mm
25mm
25mm
12
mm down
14
mm down
25
mm down
down for take off
14
mm down
16
mm down
30
mm left
down for landing
49
Advertisement
Table of Contents
