Control Throws; Flight Preparation Pre Ight Check - Black Horse Model BH136A Instruction Manual Book

SPITFIRE MX
In order to obtain the CG specified, reposition
the receiver and other equipment.
If not obtain the CG specified, add a weight and
adjust.

CONTROL THROWS

We highly recommend setting up a plane using
1)
the control throws listed.
2) The control throws should be measured at the
widest point of each control surface.
3) Check to be sure the control surfaces move in the
correct directions.
LOW RATE
Ailerons : 15mm up
Elevator : 12mm up
Rudder : 30mm right 30mm left
Flap : 35mm
HIGH RATE
Ailerons : 18mm up
Elevator : 16mm up
Rudder : 35mm right 35mm left
Flap : 40mm
Aileron Control
Flap Control
Item code: BH136A
CG
15mm down
12mm down
18mm down
16mm down
15mm
15mm
35mm
Do not fly before confirming the
correct location of the CG. If the
CG is incorrect, you lose control
of your airplane which leads to
accidents.
Elevator Control
Rudder Control
FLIGHT PREPARATION PRE FLIGHT CHECK
1) Completely charge your transmitter and
receiver batteries before your first day of flying.
2) Check every bolt and every glue joint in your
plane to ensure that everything is tight and well
bonded.
3) Double check the balance of the airplane.
4) Check the control surface.
5) Check the receiver antenna. It should be fully
extended and not coiled up inside the fuselage.
42
Instruction Manual
12mm
12mm
30mm
30mm