SitOnit Seating Surge C-Leg Assembly Instructions Manual page 25

Surge
Initialization
Check all cords to ensure they
are fully connected. Initialization
is recommended before using
table and is the first step when
troubleshooting issues.
1. Press the ∇ button until the table
reaches its lowest position.
2. Simultaneously, press and hold both
the ∆ and ∇ buttons. The legs will
descend at half-speed of normal
operation.
3. Continue holding the ∆ and ∇
buttons. The legs will move down
to the lowest position and will
'rebound' slightly. The rebound
indicates that the base is initialized.
4. Release the ∆ and ∇ buttons.
Initialization is complete.
Set Up the Memory
Settings
1. Press and hold the ∆ or ∇ button to
bring table to the desired height.
2. Press the S button, then press the
2 3
1, or button. The current height
of the table will be saved in the
selected position.
SETUP INSTRUCTIONS
1-Touch Memory Feature
1-Touch is enabled as default. The table
will move to the programed height with
a single press of each memory button.
The following steps allow this feature to
be toggled on or off as desired.
When this feature is disabled each
memory button must be held in until
table reaches the programmed height.
1. Press and hold down the
for 5-7 seconds until
on the digital screen. Let go of
2. Press and Release the 1 button. The
screen will display
is disabled.
3. Press the up ∆ button so the screen
now reads
H-1
S
4. Press the button until the screen
readout returns to the digital
height reading.
|
C6772 Rev B
S
button
appears
---
S
. 1-Touch
H-0
. 1-Touch is enabled
|
www.sitonit.net
.
25