Table of Contents
Advertisement
Operation
Record
The LΩGIC Wall Panel 16- Port can record control signal input (DMX, Art-Net™, or sACN) for later
playback through the display menu or by a connected LΩGIC Wall Controller.
The LΩGIC Wall Panel 16- Port has 64 recording slots. When a scene is triggered for playback, it will play
continuously until it is stopped or another recording is triggered.
Due to memory capacity it is only recommended to record several seconds of a single look
to each recording slot.
Recording
To record a scene:
1. Go to the Record main menu.
2. Select the Record option.
3. Select the desired recording slot, from Record1–64.
4.
will show on the display. Press the <MENU> knob to begin recording the current control signal
input.
To prevent errors during the recording of a scene, do not change any control signal
values.
5.
will show on the display. Press the <MENU> knob to stop recording.
Display Menu Playback
To play back a recorded scene via the display menu:
1. Go to the Record main menu.
2. Select the Play option.
3. Select the desired recording slot, from Record1–64.
4.
will show on the display. Press the <MENU> knob to begin playback.
5.
will show on the display. Press the <MENU> knob to stop playback. The connected products
will black out.
•
Pressing the <MENU> knob again at this point will restart the recording.
•
If no scene is recorded to a recording slot, it cannot be selected for playback.
6. Press <ESC/BACK> to exit.
Scene Brightness (via Display Menu)
To set the Brightness of the connected LΩGIC products from 000–255 during playback of a scene, turn
the <MENU> knob clockwise or counterclockwise.
LΩGIC Wall Controller Playback
To play back a recorded scene via a connected LΩGIC Wall Controller:
1. Press the numbered button which corresponds with the number of the desired recording slot to
begin playback.
2. Press that same button again to stop playback. The connected products will black out.
•
Pressing the same button again (without holding) at this point will restart the recording.
•
If no scene is recorded to a recording slot, pressing the corresponding button will do
nothing.
Scene Brightness (via LΩGIC Wall Controller)
To increase or decrease the brightness of the connected LΩGIC products during playback of a scene,
press the <+> or <-> buttons on the LΩGIC Wall Controller.
Scene Lock
To lock a scene in place and prevent tampering:
1. Trigger a scene via the LΩGIC Wall Controller. A scene cannot be locked if no scene is playing
back.
2. Press and hold the same button for 6-10 seconds. The backlight will flash to indicate the scene is
locked.
3. Press and hold the button again to release the lock.
LΩGIC Wall Panel 16- Port User Manual Rev. 1
40
Advertisement
Table of Contents
