Table of Contents
Advertisement
LΩGIC Wall Controller
Each LΩGIC Wall Panel 16- Port comes with a LΩGIC Wall Controller which can plug into the RJ12
connector on the back of the product.
•
Buttons 1–8 trigger playback of the corresponding recorded scenes (see Record).
•
After triggering a scene, press that button again and hold it for 6-10 seconds to lock the controls
and prevent tampering. The selected button's LED backlight will flash to indicate success. Press
and hold the button again to unlock the controls. See
•
Buttons 9 and 10 decrease and increase the brightness of the connected LΩGIC products.
•
5-bit DIP switches set the address of the LΩGIC Wall Controller with a binary number value. Each
LΩGIC Wall Controller must have a unique address set by this DIP switch (from 0–31), or the
LΩGIC Wall Panel 16- Port will be unable to respond to any LΩGIC Wall Controller. The order of
addresses does not matter, only that they do not repeat.
•
The LΩGIC Wall Panel 16- Port contains 2 output ports for the LΩGIC Wall Controller protocol, so
up to 32 LΩGIC Wall Controller products can be chained to one LΩGIC Wall Panel 16- Port,
allowing versatile and convenient control from multiple locations.
•
The LΩGIC Wall Controller requires an RJ12 cable with flipped/reversed wiring. See
Wiring
for more information.
RJ12 Cable Wiring
The LΩGIC Wall Controller requires an RJ12 cable with flipped/reversed wiring. This means that pin 1 on
one side connects to pin 6 on the other side, pin 2 connects to pin 5, pin 3 connects to pin 4, and so on.
Using an RJ12 cable without flipped wiring may damage the product.
RJ12 6P6C
WARNING! The LΩGIC Wall Controller requires a flipped/reverse RJ12 cable! Incorrect
wiring may damage the product!
9
DIP switches use binary addressing
5=1
5-1 (ON)
4=2
4-0
Example:
3=4
3-1 (ON) = 00101 = 5
2=8
2-0
1=16
1-0
Scene Lock
for more information.
1–8
9
RJ12 6P6C
LΩGIC Wall Panel 16- Port User Manual Rev. 1
Setup
RJ12 Cable
10
Advertisement
Table of Contents
