Table of Contents
Advertisement
Operation
Renew
To re-scan for connected LΩGIC products:
1. Go to the Linked Fixture main menu.
2. Select Status.
3. Select Renew.
4. Select from No (cancel) or Yes (renew).
Control Personality (Global)
To set the control personality of all connected LΩGIC products at once:
1. Go to the Linked Fixture main menu.
2. Select the Personality option.
3. Select the desired personality, from RED, GREEN, BLUE, WHITE, TW, RGB, RGBW, RGBW+D,
or FULL.
•
See the
Starting Address
personality.
•
Make sure that the starting addresses on the various products do not overlap due to the new
personality setting.
Power Selection
To set the maximum output level for all connected LΩGIC products:
1. Go to the Linked Fixture main menu.
2. Select Power Selection.
3. Select from Power 100%, Power 50%, or Power 30%.
Breaking Signal
To set how the LΩGIC Wall Panel 16- Port will respond to losing the control signal:
1. Go to the Linked Fixture main menu.
2. Select Breaking Signal.
3. Select from:
•
Current State (holds the current value),
•
Blackout (blacks out all connected LΩGIC products),
or
•
White (sets all connected LΩGIC products to full output).
LΩGIC Wall Panel 16- Port User Manual Rev. 1
section for the highest starting address you can select for each
36
Advertisement
Table of Contents
