Art-Net™ Connection; Sacn Connection; Ethernet Connection Diagram; Terminating Cat6 Cables With Rj45 Connectors - Iluminarc LOGIC User Manual

Art-Net™ Connection
Art-Net™ is an Ethernet protocol that uses UDP/IP which transfers a large amount of DMX512 data using
an ethernet connection over a large network. An Art-Net™ protocol document is available from
www.iluminarc.com.
Art-Net™ designed by and copyright Artistic Licence Holdings Ltd.

sACN Connection

Also known as ANSI E1.31, streaming ACN is an Ethernet protocol that uses the layering and formatting of
Architecture for Control Networks to transport DMX512 data over IP or any other ACN compatible network.

Ethernet Connection Diagram

To other Art-Net™ or sACN devices

Terminating CAT6 Cables with RJ45 Connectors

The LΩGIC Wall Panel 16- Port communicates with Art-Net™ or sACN controllers and with connected
LΩGIC products via RJ45 ethernet ports. In many applications, a cable with an attached connector will not
fit through the required space, but will fit without the connector.
The LΩGIC system requires the use of T568B standard cable termination. Use the following table and
diagram to ensure the RJ45 connectors are installed correctly to the CAT6 cables.
Pin Wire Color
1 White/Orange
2 Orange
3 White/Green
4 Blue
5 White/Blue
6 Green
7 White/Brown
8 Brown
11
Computer/
controller
(running Art-Net™
or sACN protocol)
Pair
2
Pair 2
2
3
1
Pair 1 Pair 3
1
3
4
Pair 4
4
Diagram
RJ45 T568B
LΩGIC Wall Panel 16- Port User Manual Rev. 1
Setup
Switch or router
LΩGIC Wall Panel
To LΩGIC products
RJ45 T568B