Knockouts - Iluminarc LOGIC User Manual

Setup

Knockouts

The LΩGIC Wall Panel 16- Port has numerous knockouts. Knockouts are partially stamped removable
openings in electrical enclosures and boxes. Knockouts are pre-designed and can be removed in order to
allow electrical wiring to run through the enclosure.
To remove a knockout from the LΩGIC Wall Panel 16- Port:
1. Identify which knockout to remove.
When deciding which knockout to remove, select the knockout that would allow the wires
to remain straight with the least amount of bending.
2. Locate the knockout's attachment point.
Each knockout has an attachment point -a small tab that has not been stamped and
connects the knockout to the enclosure.
3. Place the tip of a flat-head screwdriver inside the edge of the knockout, on the opposite side of the
attachment point.
4. Press the screwdriver or hit the end of the screwdriver to partially detach the knockout.
If the knockout still does not dislodge, additional pressure may be required. Use a hammer
and hammer the screwdriver until the knockout is partially released.
5. Twist the partially detached knockout to completely remove it from the enclosure.
6. OPTIONAL: Once the knockout has been removed, install a strain-relief clamp to hold the wiring in
place and prevent it from being damaged by the end of the enclosure.
LΩGIC Wall Panel 16- Port User Manual Rev. 1 18