Table of Contents
Advertisement
Setup
Signal Connections
The LΩGIC Wall Panel 16- Port can receive a DMX, RDM, Art-Net™, or sACN control signal. If using other
compatible products with this product, each can be individually controlled with a single controller.
Control Personalities
The LΩGIC Wall Panel 16- Port uses a 5-pin phoenix connection to receive DMX or RDM, or an ethernet
connection to receive Art-Net™ or sACN, and a CAT6 ethernet connection to send control data to
connected products for its 9 control personalities, ranging from 1 to 10 channels.
•
Refer to the
Operation
these personalities.
•
The
Control Channel Assignments and Values
control personalities.
For more information about DMX standards or the DMX cables needed to link this product
to a DMX controller, download the DMX Primer from the Chauvet website:
www.iluminarc.com.
DMX Linking
The LΩGIC Wall Panel 16- Port will work with a DMX controller using a 5-pin phoenix connector. For more
information about DMX, read the DMX primer at:
uploads/2016/06/DMX_Primer.pdf.
DMX Output
Remote Device Management
Remote Device Management, or RDM, is a standard for allowing DMX-enabled devices to communicate
bi-directionally along existing DMX cabling. Check the DMX controller's User Manual or with the
manufacturer as not all DMX controllers have this capability. The LΩGIC Wall Panel 16- Port supports
RDM protocol that allows feedback to make changes to menu map options.
DMX/RDM Connection Diagram
DMX or RDM Controller
To other DMX or RDM devices
LΩGIC Wall Panel 16- Port User Manual Rev. 1
chapter to learn how to configure the LΩGIC Wall Panel 16- Port to work in
https://www.chauvetprofessional.com/wp-content/
1. Ground
2. Data 1 -
3. Data 1 +
4. Not used
5. Not used
section provides detailed information regarding the
Signal Connector
LΩGIC Wall Panel 16- Port
LΩGIC
products
10
Advertisement
Table of Contents
