Start-Up Recommendations; System Protection; Pre Start-Up Recommendations Of The Unit (In The Presence Of The End-User) - Salda RIS 700 H EKO 3.0 Mounting And Installation Instruction

• After installation of the ventilation unit, the power network plug socket must be accessible at any time. If the unit is equipped with circuit breaker,
disconnection from the power network is performed through the two-pole or four-pole circuit breaker (by disconnecting phase poles and neutral).
• Before it is connected to the power network, the unit must be carefully checked for any damage (operation, control, and measurement nodes)
made during transportation.
• The power cable can be replaced only by a qualified technician,
The manufacturer does not assume any liability for personal injuries and property damage due to non-conformance with the
provided instructions.
5.8.

START-UP RECOMMENDATIONS

5.8.1. SYSTEM PROTECTION

The control board of the unit is equipped with the following integrated devices for the protection against short circuit:
RIS H EKO 3.0
F1
F2
It is recommended to use the unit with an external electrical protection device.
RIS H EKO 3.0
Mains Fuse
To ensure safe maintenance of the unit, it is necessary to turn off the main switch and/or external protection device.

5.8.2. PRE START-UP RECOMMENDATIONS OF THE UNIT (IN THE PRESENCE OF THE END-USER)

Prior to start-up, the system must be carefully cleaned. Check for the following:
• Operation systems and unit elements as well as automation and automation devices were not damaged during installation,
• All electrical devices are connected to power supply and fit for service,
• All necessary automation elements are installed and connected to power supply and terminal blocks,
• Cable connection to terminal blocks comply with the existing wiring diagrams,
• All electrical equipment protection components are properly connected (if they are additionally used),
• Cables and wires correspond to all applicable safety and functional requirements, diameters, etc.,
• Earthling and protection systems are properly installed,
• Condition of all seals and sealing surfaces is proper.
12 | EN
after the evaluation of
700 HEL 700 HER
10 A
6,3 A
700 HEL 700 HER
16A
the rated power and current.
700 HWL
10 A 6,3 A
6,3 A 1 A
700 HWL
16A 6A
700 HWR
6,3 A
1 A
700 HWR
6A
RIS 700 H EKO 3.0 v2023.1